Grizzly G0724 owner manual Test Run, To test run the machine

Test Run

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.

The test run consists of verifying the following:

1)The motor powers up and runs correctly, and

2)the safety disabling mechanism on the power switch works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 22.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

2.Make sure all tools and objects used during setup are cleared away from the machine.

3.Verify that the machine is operating correctly by turning it ON.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

4.Turn the machine OFF.

5.Remove the switch disabling key, as shown in Figure 11.

Figure 11. Removing switch key from paddle

switch.

6.Try to start the machine with the paddle switch.

—If the machine does not start, the switch disabling feature is working as designed. The test run is now complete.

—If the machine starts, immediately stop the machine and disconnect power. The switch disabling feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.

Model G0724 (Mfg. Since 09/11) -15-