Dust Collection | Power Connection | |
|
|
|
|
|
|
The Model G0724 has a built in dust collection fan and includes a dust collection bag. It has a 2.5" dust port that can be hooked up to a
DO NOT operate the Model G0724 with- out an adequate dust collection system. This machine creates substantial amounts of wood dust while operating. Failure to use a dust collection system can result in short and
Recommended CFM at Dust Port: 150 CFM
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust collector,
(2)hose type and length between the dust col- lector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to cal- culate these variables is beyond the scope of this manual. Consult an expert or purchase a good dust collection
To install the dust collection bag:
1.Attach the dust collection bag to the dust port, as shown in Figure 8.
Bag
Clamp
Dust
Port
Figure 8. Attaching the dust collection bag.
After you have completed all previous setup instructions and circuit requirements, the machine is ready to be connected to the power supply.
To avoid unexpected startups or property dam- age, use the following steps whenever connecting or disconnecting the machine.
Connecting Power
1.Turn the machine power switch OFF.
2.Insert the power cord plug into a matching power supply receptacle. The machine is now connected to the power source.
Figure 9. Connecting power.
Disconnecting Power
1.Turn the machine power switch OFF.
2.Grasp the molded plug and pull it completely out of the receptacle. Do not pull by the cord as this may damage the wires inside.
