Grizzly G1022ZFX instruction manual Adjustments, G1022SM Fence

SECTION 5: ADJUSTMENTS

!Disconnect power to the machine when perform-

ing any maintenance, assembly or adjust- ments. Failure to do this may result in serious personal injury.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses during the entire adjust- ment process. Failure to comply may result in serious personal injury.

G1022SM Fence

(The Model G1022ZF, ZFX and PRO use a Shop Fox¨ fences. Please refer to the instruction man- ual included with the Shop Fox¨ fences for com- plete directions on adjusting.)

The fence must engage and square up on the front rail before the rear clamp engages the back rail. In essence, the rear clamp should act as a secondary mechanism for maintaining fence position. When adjusted correctly, the lever lock should only begin to apply pressure on the back rail over the last one-third of its stroke. To adjust the fence:

1.First, make sure the front clamp is engaging the front rail with the lock handle at one-half of its throw. If the front clamp requires adjust- ment, loosen the check nut shown in Figure 32. Turn the adjusting bolt clockwise if the front clamp is too far from the rail, or counter- clockwise if it is too close.

Adjusting Bolt

Check Nut

Figure 32. Adjusting clamp mechanism.

2.Now slide the fence along the rail until it is aligned with the edge of the miter slot. Lock the fence down.

G1022 Series Contractor Saws -27-