4.If anything appears abnormal, immediately turn off the saw and fix the problem. If a problem exists that is beyond the scope of this manual, call our service department.
5.If the saw is behaving normally, turn it off and prepare to make a cut according to the instructions outlined in the following sec- tions.
2.Cross-cut Blade: Used for cutting across the grain. 10" cross-cut blades have between 60-80 teeth (Figure 51), alternate top bevel or steep alternate top bevel tooth profiles, small hook angle and a shallow gul- let.
Blade Selection
Choosing the correct blade for the job is essential for the safe and efficient use of your table saw. Ignoring this important step could result in dam- age to the saw and serious injury to the operator. Documented below are the most common saw blades and their uses.
1.Rip Blade: Used for cutting with the grain. Typically, 10" rip blades have between 20-40 teeth (Figure 50), flat-top ground tooth pro- file and large gullets to allow for large chip removal.
Figure 51. Crosscutting blade.
3.Combination Blade: Used for cutting with and across the grain. A compromise between a rip blade and a cross-cut blade, a 10" combination blade will typically have between 40-50 teeth (Figure 52), an alter- nate top bevel and flat or alternate top bevel and raker tooth profile. The teeth are arranged in groups of five. The gullets are small and shallow within the groups of five teeth, similar to a cross-cut blade; then large and deep between the groups, like a ripping blade.
Figure 50. Ripping blade.
-36-
Figure 52. Combination blade.
G1022 Series Contractor Saws
