Grizzly G1022ZFX instruction manual Maintenance, General, Lubrication, Tables, Belt

SECTION 7: MAINTENANCE

General

!Disconnect power to the machine when perform-

ing any maintenance or repairs. Failure to do this may result in serious personal injury.

Keep clothing rolled up and out of the way of machinery and keep hair pulled back.

Wear safety glasses dur- ing the entire mainte- nance process. Failure to comply may result in serious personal injury.

Regular periodic maintenance on your Model G1022 Series will ensure its optimum perfor- mance. Make a habit of inspecting your machine each time you use it. Check for the following con- ditions and repair or replace when necessary:

1.Loose mounting bolts.

2.Worn switch.

3.Worn or damaged cords and plugs.

4.Damaged V-belt.

5.Any other condition that could hamper the safe operation of this machine.

6.Inspect blades for damage.

7.Guard alignment and operation.

Lubrication

The sealed ball bearings in the motor and throughout the Model G1022 Series require no further lubrication during their lifetime. When they do wear out, replacements can be obtained through the Grizzly Parts Department. Lubricate the areas indicated below every 12 months.

1.Blade angling trunnions. These should be lubricated with 6 or 7 drops of light machine oil.

2.Blade height trunnion. This should also be lubricated with 6 or 7 drops of light machine oil.

3.The two (2) worm gears should be lubricat- ed with an automotive wheel bearing grease.

Tables

Tables can be kept rust-free with regular applica- tions of products like Boeshield¨ T-9. For long term storage you may want to consider products like Kleen Bore's Rust Guarditª.

V-Belt

Inspect regularly for tension and wear. Check pul- leys to ensure that they are properly aligned. See pulley/V-belt sections for proper tension and pul- ley alignment procedures.

-42- G1022 Series Contractor Saws