Blade |
| Blade Guard |
|
|
|
|
|
|
The Model G1023 is not supplied with a blade. For a selection of blades, including dado sets, refer to the Grizzly catalog for selection, price and ordering information. To install the blade:
1.Remove the arbor nut and outside arbor flange from inside the blade cavity. Figure 7. The arbor nut and arbor are left hand thread- ed.
2.Slide the saw blade over the arbor. Ensure that the blade teeth point toward you when standing at the front of the saw.
3.Use the arbor wrench provided with the saw to tighten the arbor nut and secure the blade. Wedge a block of wood in the teeth to keep the blade from turning when tightening the nut. Be sure the arbor flanges are on either side of the blade.
4.When removing the blade, use the same block of wood to wedge the blade and the nut will come off easily.
Figure 7.
1.Slip the blade guard/splitter over the mount- ing bolts. Figure 8. The washers should be between the bolt head and the slots. Tighten the bolts to secure the blade guard/splitter.
Figure 8.
2.Set a combination square against the face of the guard. Slightly rotate the rear bracket to adjust the face of the blade guard perpendic- ular to the table top. Figure 9.
Figure 9.
G1023 |
