Figure 4.
8.If the wing tilts down, remove the wing and stick layers of masking tape under each bolt near the bottom edge.
9.If the wing tilts up, remove the wing and stick layers of masking tape over each bolt near the top edge.
Guard Support Shaft
Install the guard support shaft before installing the blade. This will eliminate the risk of acciden- tally touching the sharp edges of the blade while working inside the saw cabinet.
1.Push the threaded end of the shaft through the hole in the back of the saw until the shoulder on the shaft stops it.
2.Secure the shaft with the hex nut provided.
Figure 6.
Figure 6.
Masking Tape
Figure 5.
|
|
|
|
|
|
|
|
|
| G1023 | |
|
|
