SECTION 5: OPERATIONS
|
| Test run |
|
|
|
|
|
|
Before you begin to use your model G1023 Table Saw, you should give it a thorough inspection. While making your inspection, ask yourself the following questions:
1.Are all the fasteners tight?
2.Is the blade mounted correctly and securely?
3.Is the saw stable?
4.Is it wired properly?
5.Is your electrical system properly config- ured?
6.Have you checked your material for obvious defects?
7.Are the
8.Is the guard assembly installed and function- al?
The table saw is one of the most valuable tools in the woodshop because it performs its duties so well. It is primarily intended to rip and crosscut and we will describe those operations in the fol- lowing sections. For other uses, we suggest con- sulting a book dedicated to the table saw. Many are available through the Grizzly catalog.
1.Face the table saw and stand to the left of the blade path.
2.With one finger on the “Start” button and one finger on the “Stop” button, turn the saw on. Be ready to turn it off in case of mishap.
3.Watch and listen to the saw. Note whether there are any unusual sounds or excessive vibrations.
4.If ANYTHING appears abnormal, immedi- ately turn off the saw and fix the problem. If a problem exists that is beyond the scope of this manual, call the appropriate service department.
5.If the saw is behaving normally, turn it off and prepare to make a cut according to the instructions outlined in the following sec- tions.
|
|
|
|
|
|
|
|
|
|
|
|
G1023 | |||
