90˚ Positive Stop
Your table saw will be easier to use and produce more predictable results if it is adjusted correctly. Next to parallelism, the 90° positive stop is per- haps the most important adjustment point on the saw. To adjust the 90° positive stop bolt:
1.Turn the arbor tilting handwheel (the one on the left side of the saw) until the 90° positive stop limits movement.
2.Check the angle of the blade to the table with a high quality square. Figure 19. If the blade is 90° to the table, you are finished. If the blade is not exactly 90° to the table, proceed to the next steps.
3.Angle the blade toward 45° to allow access to the stop bolt.
4.Locate the stop bolt on the geared trunnion inside the cabinet. Figures 20.
Figure 19.
Figure 20. Location for 90˚ positive stop.
5.Loosen the jam nut and thread the stop bolt in or out not more than a half turn. Figure 21.
6.Tighten the jam nut and tilt the blade back to 90°. Check the angle of the blade with the square.
7.Repeat steps 3-6 as necessary.
Geared
Trunnion
90° Stop Bolt
Jam Nut
Front
Trunnion
Figure 21.
|
|
|
|
|
|
|
|
|
|
|
|
G1023 | |||
