5.Loosen the locking lever until it is approxi- mately
6.Loosen the locking lever and slide the fence along the rail. Return the fence to its position at the edge of the miter slot and slowly apply pressure to the lever. If adjustments are cor- rect, the fence should square itself before the rear clamp engages. If the rear clamp engages before the fence is squared, loosen the screw one quarter turn and
7.Once the fence is adjusted, check the point- er and adjust if necessary. Figure 29.
Figure 29.
Blade Alignment
The blade position can be adjusted slightly in case it contacts the table insert when raised. To adjust the blade position:
1.Remove the table and wings and set them aside.
2.Loosen the blade adjustment bolt. Figure 30.
Blade Adjustment Bolt
Geared Bearing Housing
Figure 30.
3.Shift the geared bearing housing in the appropriate direction. WARNING: This adjustment should not exceed 1⁄16". Over adjustment will cause the blade to hit internal parts of the saw.
4.Place the blade on the arbor and finger tight- en the arbor nut. Check that the blade does not contact any internal parts.
5.Replace the table, wings, and insert. Tighten securely.
6.If the blade is still touching the insert, repeat steps
MENTS.
|
|
|
|
|
|
|
|
|
|
|
|
G1023 | |||
