Switch |
| Extension Wings |
|
|
|
|
|
|
The magnetic switch comes prewired to the motor. However, you must mount the switch to the table saw body before it can be used. A bracket with screws to attach it is provided.
Figure 3.
Figure 3.
Inspect the extension wings for burrs or foreign material that may inhibit assembly. The mating edges of the wings and table must be clean, smooth, and flat. Use a wire brush or file if nec- essary to clean up the edges. It is possible to attach the extension wings to the table by your- self, but it is easier if someone else holds the wing in place while you insert the bolts.
1.Attach each wing to the table using the six 3⁄8" - 16 x 1 1⁄4" Hex Head Bolts and 3⁄8" Flat Washers provided. Get the wings reason- ably flush with the table. Do not tighten the bolts.
2.Align the top of the wing flush with the table top directly above the front bolt and tighten the front bolt. The front surface of the exten- sion wing should also be flush with the front surface of the table.
3.Raise or lower the rear of the extension wing until the middle of the wing is flush with the table top. Tighten the middle bolt.
4.Raise or lower the rear of the wing until the wing and table are flush. Tighten the bolt. Any adjustment at this point should be very slight.
5.
6.Repeat steps
7.Now, check the alignment of the table and both wings with a straight edge. The straight- edge should run flat across both wings and the table top. Figure 4. If the straightedge contacts both wings and the table evenly, you are finished with this section. If it does not, continue to step 8.
G1023 |
