45˚ Positive Stop
To adjust the 45° positive stop bolt:
1.Turn the arbor tilting handwheel (the one on the left side of the saw) until the 45° positive stop limits movement.
2.Check the angle of the blade to the table with a high quality angle gauge. Figure 22. If the blade is 45° to the table, you are finished. If the blade is not exactly 45° to the table, pro- ceed to the steps below.
3.Angle the blade toward 90° to allow access to the stop bolt.
4.Locate the stop bolt on the geared trunnion inside the cabinet. It is accessed through the hole in the side of the cabinet behind the blade height hand wheel. Figure 23.
Figure 22.
5.Loosen the jam nut behind the 45° stop bolt. Tighten or loosen the stop bolt to adjust the stopping position of the arbor. Tighten the jam nut.
6.Tilt the blade until the 45° stop bolt prohibits movement. Check the angle of the blade.
7.Repeat steps
Jam
45° Stop Bolt
Figure 23.
G1023 |
