Motor Brace
The motor brace shown in Figure 11 has been installed for shipping purposes. Please remove this brace before continuing with assembly. The bolts that secure the brace should be screwed back in at the locations from which they came.
Figure 11. Motor Brace.
Figure 12. Attaching guard support shaft.
3.Slide the lower half of the bracket onto the splitter shaft and temporarily tighten the setscrews.
4.Place the upper bracket half on the lower half and secure both halves with the bolts nuts and four washers as shown in Figure 13. Do not fully tighten the nuts at this moment.
Guard Bracket
To install the guard support shaft:
1.Place the threaded end of the shaft through the hole in the back of the saw (Figure 12).
2.Thread the shaft into the tilt assembly.
Figure 13. Splitter bracket installed.
|
|
|
|
|
|
|
|
|
|
|
|
G1023SL/G1023SLX | |||
