Dust Port
Mount the the dust port onto the cabinet stand with the 4 Phillips¨ screws as shown in Figure 16.
Figure 16. Dust port installed on cabinet.
Saw Blade
The saw blade is extremely sharp. Use extra care when handling the blade or working near it. Serious injury is possible.
Please review this section even if your saw blade came
1.Remove the table insert to gain access to the arbor.
2.Remove the nut and the outer arbor flange from the arbor.
3.Place the blade on the arbor, making sure that it seats firmly against the inner arbor flange. Ensure that the top blade teeth are facing the front of the saw.
4.Replace the outer arbor flange and rethread the arbor nut onto the arbor.
5.Hand tighten the nut and snug with the wrench included with the saw. DO NOT overtighten.
IMPORTANT: Make sure the blade is installed with the teeth facing the front of the saw.
Blade Guard/Splitter
1.Slip the blade guard/splitter over the mount- ing bolts as shown in Figure 17. The wash- ers should be between the bolt head and the slots. Tighten the bolts to secure the blade guard/splitter.
Blade Guard |
Mounting Bolts |
Figure 17. Blade guard and splitter in place.
2.Set a machinistÕs square against the face of the blade splitter. Slightly rotate the rear bracket to adjust the face of the blade splitter perpendicular to the table top as shown in
Figure 18.
G1023SL/G1023SLX |
