Common Definitions, Terms and Phrases
The following is a list of common definitions, terms and phrases used throughout this manual as they relate to this table saw and woodworking in general. Becoming familiar with these terms is important before assembling, adjusting or operating this machine. Your safety is VERY important to us at Grizzly!
Arbor: Metal shaft extending from the drive mechanism, to which cutting blade is attached.
Bevel Edge Cut: Tilting the saw arbor and blade to an angle between 0¡ and 45¡ to perform an angled cutting operation.
Blade Guard: Metal or plastic mechanism that mounts over the saw blade to prevent acciden- tal contact with the cutting edge.
Crosscut: Table saw operation in which the miter gauge is used to cut across the grain of a piece of wood.
Dado Blade: Blade or set of blades that attach to the arbor and are used for cutting grooves and rabbets.
Dado Cut: Table saw operation that uses a dado blade to cut a flat bottomed groove into the face of wood stock.
Featherboard: Safety device used to keep a board against the rip fence or table. Allows operator to keep hands away from the saw blade.
Kerf: The resulting cut or gap made by a saw blade.
Perpendicular: Intersecting and forming right angles; at right angles to the vertical and hori- zontal planes. i.e. the blade is perpendicular to the table surface.
Push Paddle: Safety aid used to push a piece of wood stock through a cutting operation.
Push Stick: Safety aid used to push a piece of wood stock through a cutting operation. Usually used when rip cutting.
Rabbet: Cutting operation that creates an L- shaped channel along the edge of wood stock.
Splitter: Metal plate attached to the back of the blade guard that maintains the kerf opening in the wood when performing a cutting operation.
Standard Kerf: 1Ú8" gap made with a standard blade.
Kickback: An event in which the wood is thrown back toward an operator at a high rate of speed.
Miter Gauge: A component that controls the wood stock movement while performing a crosscut. Allows for variation of angle cuts such as miter cuts used on a picture frame.
Moulding Head: A cutterhead attached to the arbor. Accepts interchangeable moulding knives for profile cutting. We DO NOT recom- mend the use of moulding heads because they require advanced skills for their operation.
Parallel: Being an equal distance apart at every point. i.e. the rip fence face is parallel to the side face of the saw blade.
G1023SL/G1023SLX
Straightedge: A tool used to check the flatness, parallelism, or consistency of a surface(s).
Through Cut: A sawing operation in which the wood stock thickness is completely sawn through. Proper blade height usually allows 1Ú4" of the top of the blade to extend above the wood stock.
Thin Kerf: 3Ú32" gap made with a thin kerf blade.
Rip Cut: A cut made along the grain of the wood.
Sacrificial Fence: A piece of wood attached to the face of the rip fence that is designed to extend the fence face away from the metal por- tion of the fence. Used primarily when making rabbet cuts with a dado blade.
