-34- G1023SL/G1023SLX Left-Tilting 10'' Table Saw
SECTION 7: MAINTENANCE

V-Belt

To ensure optimum power transmission from the
motor to the blade, the V-belts must be in good
condition and operate under the proper tension.
When replacing V-belts, replace all three at the
same time —even if they do not all appear worn.
Belt tension should be checked at least every 3
months; more often if using the table saw inten-
sively.
The V-belts are accessed through the cavity on
the right side of the saw. They link the arbor and
motor pulleys. To check V-belt tension:
1. With moderate pressure, push the center of
each V-belt.
2. Note the amount of deflection. Deflection
should be approximately 12", similar to
Figure 42.
Figure 42. Belt deflection.

Tables

The nonpainted surfaces on the Model
G1023SL/G1023SLX should be protected
against rust and pitting. Wiping the machine
clean after every use ensures that wood dust is
not allowed to trap moisture against bare metal
surfaces.
Tables can be kept rust-free with regular applica-
tions of products like SLIPIT®. For long term stor-
age you may want to consider products like
Boeshield T-9™.
Regular periodic maintenance on your Model
G1023SL/G1023SLX will ensure its optimum per-
formance. Make a habit of inspecting your
machine each time you use it. Check for the fol-
lowing conditions and repair or replace when
necessary:
1. Guard alignment and operation.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Loose mounting bolts.
6. Inspect blades for damage.
7. Any other condition that could hamper the
safe operation of this machine.

General

Disconnect power to the
machine when perform-
ing any maintenance or
repairs. Failure to do this
may result in serious
personal injury.