11.Refer to Figures 26 and 27, for shim place- ment. If the distance of A is shorter than B, shim(s) will need to be placed under corners #1 and #2. If the distance of B is shorter than A, shim(s) will need to be placed under cor- ners #3 and #4. Very thin shim stock works well, just make sure they are all the same thickness, and you put an equal number under each of the two corners.
12.Tighten down one bolt a small amount and then move on to each of the others, tighten- ing each down the same amount. Continue to rotate through the bolts, tightening them a little each time until they are all secure.
13.Now recheck the blade to miter slot at 90¡ and 45¡ by repeating Steps
14.Once you feel you have the miter slot adjust- ed to the blade, recheck all measurements and be sure the table mounting bolts are secure. Repeat Step 10 in Section 4: Assembly, ÒBlade Guard/Splitter.Ó Also, if you ever remove the table in the future, be sure to make note of shim placements and reassemble exactly how it came apart.
Figure 26. Shim procedure diagram A.
Figure 27. Shim procedure diagram B.
|
|
|
|
|
|
|
|
|
|
|
|
G1023SL/G1023SLX | |||
