Installing OP-04 | A&D HV-G Series guide

Circuit

Caution

Please confirm that the AC adaptor type is correct for your local voltage and receptacle type.

Selection switch for the RS-422/ RS-485 interface

Selects either of RS-422 or RS-485 interface using a switch on the board.

Installing OP-04

Step 1 Remove two screws that attach the RS232C board on the rear of the display unit. Remove the RS232C board.

Step 2 Switch the connections. Step 3 Insert the option board into the

display unit and afix with the screws

HV-G Instruction Manual Page 58

Image 59

A&D HV-G Series instruction manual Installing OP-04

Contents

HV-G Series Contents Page Compliance with FCC rules Compliance Outline and Features Unpacking Type Products Accessories Accessories and Options list Options List Order code or option name Accessories Precautions for Storing the Scale Precautions for Installing the ScalePrecautions for Operating the Scale Installing the Scale Installing the Batteries for Type L Names OFF Display and SymbolsPage Switches Page Memo Basic OperationTurning the Scale On/Off & Basic Weighing Type L with Batteries Semi-Automatic Tare Input by Weighing Tare and Net Display Products Weighing Range Weighing RangeWeighing Range Operation and Performance Mode Switch Changing Unit & Mode Storing a Unit Mass Counting Mode Counting the number of articles Storing a 100% Mass Percentage Mode Reading Percentage Function table Meaning & Purpose Operation and SwitchesAccumulation Function Preparation Setting Parameters Example Operation and Performance Examples Function table Meaning and Purpose Comparator FunctionComparator Sign Comparison Condition Accumulation function f6 Step If one Has Been selected, press Case Full/Dribble Batch Function Hold ComparatorFull/Dribble batch sub-function Parameter and display an item of the full/dribble Switch to display the HI Function Table Meaning and purpose Simple batch function Simple Batch Function Preparation Setting Parameters Operation and Performance Examples Calibration Adjusting the Scale Gravity Acceleration Table Gravity Acceleration Correction Complete Calibration Procedure Calibration of the Zero Point Function Table Procedure for Setting Parameters 15.2 Parameter List Function or full/dribble batch function Display Meaning and purpose Printing condition when using option OP-06 for type Function to hold the current display value. When 16 RS-232C Serial Data Interface Format Data Format Format Preparation and Performance Examples Stream Mode Tare Command ModeCancel of tare Upper limit value Preset tare Final value Preparation Setting Parameters 17.1 RS-232C / Relay output / Buzzer OP-03 Pin connections Pin No Signal name Direction DescriptionOptions 17.2 RS-422 / RS-485 / Relay output OP-04 Pin No Signal name Direction Description Installing OP-04 Communication Format Lower limit value Zero Final value Reset of Accumulation data and numberAccumulation data output Accumulation count output Consumables SpecificationInternal Printer for Type V OP-06 Installation Disassembly Performance Check HV-G series Specifications Dimensions Page This situation Confirm these items MaintenanceCheck Points Before Calling Maintenance Repair