A&D HV-G Series instruction manual Parameter List

15.2

Parameter List

Item

Display

Meaning and purpose

The type L scale is turned off after 5 minutes of no operation,

when displaying zero.

Automatic

f1 0 #

Not used

turning off

f1 1

Used

Selects the method of changing the weighing range

Range

f2 0 #

Automatic range change.

f2

1

Manual range change using the

switch.

RANGE

Transmission rate of the serial

interface

(RS-232C/ 422/485).

f4

0

#

2400bps

Baud rate

f4 1

4800bps

f4

2

9600bps

Mode selection for the serial interface (RS-232C/ 422/485).

f5

0

#

Stream mode. (Refer to “16.2 Stream Mode”)

f5

1

Command mode. (Refer to “16.3 Command Mode”)

f5

2

A data is output, when the

switch is pressed.

PRINT

f5

3

Auto-print +

When the display becomes a positive stable value above

near-zero, the scale outputs the data automatically. Next

Output mode

output can be performed after the display becomes near-

zero or a negative value.

f5 4`

Auto-print +/-

When the display becomes a stable value outside near-zero,

the scale outputs the data automatically. Next output can be

performed after the display becomes near-zero.

f5 5

At each finish of full/dribble batch function, the data is output.

f6 0 #

The scale always compares the current display value. Pressing

the

switch turns the comparator on and off

SET

f6 1

The

scale always compares the display value.

Comparator

f6 2

The scale always compares the display value if not near-zero.

Pressing the

switch turns the comparator on and off

SET

f6 3

The scale always compares the display value when not

near-zero.

Notes

The “#” indicates factory settings.

The “near-zero” is within ±4 digits from zero point in the unit of kg.

HV-G Instruction Manual Page 44