A&D HV-G Series instruction manual Printing condition when using option OP-06 for type

Item	Display	Meaning and purpose
Accumulation		When the display becomes a stable value, the scale
		accumulates the data automatically. Next accumulation can
		perform after the display becomes near-zero.
	f8 4	Use: Recording number and mass of articles removed from
		the pan. (Put articles on the pan. Press							switch at each
								TARE
		removal.)
		At each finish of full/dribble batch function, the scale
		accumulates the data automatically.
	f8 5	Use: Packing articles like a powder, it is used for recording
		the bag number and total mass.
		The printing condition when using option OP-06 for type V.
	f9 0 #	No print.
	f9 1	Pressing the					switch, the data is output.
					PRINT
		Auto-print +
		When the display becomes a positive stable value above
	f9 2	near-zero, the scale outputs the data automatically. Next
		output can be performed after the display becomes near-
		zero or negative value.
Print Mode		Auto-print +/-
		When the display becomes a stable value outside near-zero,
	f9 3	the scale outputs the data automatically. Next output can be
		performed after the display becomes near-zero.
	f9 4	At each finish of full/dribble batch function, the data is output.
	f9 5	When the accumulation function is used, the data is output.
		The details of the full/dribble batch function (B$￿')
	f10 0 #	Reaching final value and pressing the F switch, the current
		process is finished.
	f10 1	Reaching final value and displaying the stability mark, the
		current process is finished automatically.
	f10 2	Pressing the				switch, the scale automatically tares and
					SET
		starts the full/dribble batch process. Reaching final value and
		pressing the F switch, the current process is finished.
Full/Dribble	f10 3Pressing the			switch, the scale automatically tares and
			SET
Batch	starts the full/dribble batch process. Reaching final value and
sub-function	displaying the stability mark, the current process is finished.
	Address for RS-422 / RS-485 for option OP-04
	f11 00 # Use This address can be set from 01 to 99. Allows a
Address	to	computer to control a scale with the assigned address.
	f11 99	(RS-232C should be set to “00”.)

HV-G Instruction Manual Page 46