Grizzly G5045 instruction manual Bench Mounting, Stand Assembly

SECTION 4: ASSEMBLY

Bench Mounting

The Model G5045 can be mounted on a work- bench or a portable stand, in addition to its stan- dard heavy-duty base. If the saw is bench-mount- ed, it is essential to create a cutout below the saw to allow sawdust to exit the machine. The cutout should measure 11" to 12" square and should be centered underneath the saw’s frame. For maxi- mum stability, the saw should be secured to the bench with 3⁄8" lag bolts or 3⁄8" through bolts.

Stand Assembly

The G1022/G1022Z Table Saw is supplied with a heavy-duty stamped steel stand. To assemble the stand:

1.Fasten the plastic feet to all four legs using the M10 - 1.5 x 25mm Hex Bolts, 10mm Flat washers and M10 - 1.5 Hex Nuts sup- plied. See Figure 2.

Figure 2. Attaching feet to stand.

2.Locate the long upper and lower side braces (2 each) and bolt to the legs using the M8-1.25 x 16mm Carriage Bolts, 8mm Flat Washers and M8-1.25 Hex Nuts Supplied. See Figure 3. Do not tighten any stand bolts until Step 5. Finger tighten only for now.

Figure 3. Assembled side panel.

Some die-cut metal parts may have sharp edges (called “flashing”) on them after they are formed. Please examine the edges of all die-cut metal parts before handling them. Failure to do so could result in injury.

G5045 10'' Bench Top Table Saw -9-