3.Attach the short upper and lower side braces to one of the assembled side pan- els. Use the M8 - 1.25 x 16mm Carriage Bolts, 8mm Flat Washers and
Figure 4. Adding upper and lower side braces.
4.Bolt the other side panel to the upper and lower braces using the M8-1.25 x 16mm Carriage Bolts, 8mm Flat Washers and M8- 1.25 Hex Nuts supplied. See Figure 5.
Figure 5. Stand fully assembled.
5.Once the stand is assembled, hold the saw body over the top of the stand to ensure the mounting holes line up. If the holes line up, tighten the stand fasteners. Once the stand is securely tightened, set the saw on top and insert the mounting bolts through the mounting holes and secure with nuts and washers. See Figure 6.
Figure 6. Fastening stand to saw body.
6.Level the stand by checking all sides for symmetry. Measure diagonally from top to bottom and adjust the stand so both diago- nals are equal. Tighten all of the stand bolts.
G5045 10'' Bench Top Table Saw |
