Grizzly G5787 instruction manual Beginning Assembly Stand

SECTION 4: ASSEMBLY

Beginning Assembly Stand

The Model G5787 requires a moderate amount of assembly and setup. The following instructions have been provided to guide you through this process.

Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.

Disconnect power to the machine when perform- ing any maintenance or assembly. Failure to do this may result in serious personal injury.

Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.

Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.

All stand pieces except the rubber feet should be assembled with the 5⁄16"-18 x 1⁄2" carriage bolts, 5⁄16" hex nuts, and 5⁄16" washers. To assemble the stand:

1.Place the (4) mount brackets on the stand corners where the feet will be installed. The bracket fork should slide over the edge of the stand.

2.Insert the (4) 1⁄4"-20 x 1" hex bolts into the rubber feet and attach the feet to the stand corners as shown in Figure 6.

Figure 6. Rubber feet on stand sides.

-10- G5787 Meatcutting Bandsaw