Grizzly instruction manual Mounting plate to side braces G5787 Meatcutting Bandsaw

3.Attach the stand sides to the stand top as shown in Figure 7. Make sure the side of the stand with the switch cutout is on the same side as the V-belt cutout on the top piece. This will ensure that the switch is in front of the bandsaw. Do not completely tighten the carriage bolt nuts at this time.

Figure 7. Stand sides attached to stand top.

4.Attach the top brace on the underside of the stand sides as shown in Figure 8. This brace secures the center of the stand top to the stand sides.

Figure 8. Top brace to stand top.

5.Attach the motor mount to the top brace and stand top as shown in Figure 9.

Figure 9. Motor mount attached to top.

6.Attach the mounting plate to the two side braces as shown in Figure 10.

Figure 10. Mounting plate to side braces.

G5787 Meatcutting Bandsaw -11-