![](/images/new-backgrounds/1311312/31131229x1.webp)
Bandsaw Unit
To install the bandsaw unit onto the stand:
1.Place the bandsaw unit onto the stand as shown in Figure 16. Get help so you do not strain yourself.
Figure 16. Bandsaw unit onto stand.
2.Line up the holes on the stand with the holes on the bottom of the bandsaw unit.
3.Fasten the stand to the bandsaw unit with the hexagonal shaft and 1⁄2" washer as shown in Figure 17.
Figure 17. Installing hexagonal shaft.
Sliding Rails
To install the sliding rails:
1.Roll pins should already be in the rails. Line these up to their respective holes in the bandsaw unit as shown in Figure 18.
Figure 18. Rails onto bandsaw unit.
2.Fit the roll pins inside the holes. If they will not fit, roll the rail over and try the other side. Because the roll pins are slightly flared, they will often only fit on one side.
3.Tap the roll pins down into the holes with a hammer so they are flush with the top sur- face of the rail.
4.Place the 1⁄2"-12 x 3⁄4" cap screws into the rails and fasten the 1⁄2" hex nuts with wash- ers underneath so that the rails are secured to the bandsaw unit.
G5787 Meatcutting Bandsaw |