Grizzly Attaching Sandpaper, Removing protective layer G8793 12 Double Disc Sander

Attaching Sandpaper

The sanding disc sticks to the surface of the cast iron disc using the pressure sensitive adhesive backing (PSA) on the reverse side of the sand- paper disc. The sandpaper can be replaced with- out removing either the table or the dust port.

Peel back the protective layer on one-half of the sandpaper disc and fold it against the remaining half. Slip the half which still has the protective layer on it between the disc and the table edge See Figure 4. Position the exposed adhesive on

Figure 4. Sandpaper being slipped between the

disc and table.

the upper half of the disk which extends above the table. Once it is positioned evenly across the disc, press the adhesive onto the surface. Now rotate the disk so the lower half is now exposed. Bend the paper back to allow removal of the remaining half of the protective layer (See Figure 5), and then press this portion against the disk.

Figure 5. Removing protective layer.

G8793 12" Double Disc Sander -11-