!Repeat steps 1 to 6to store other
stations.
Other operations
To Do this
Tune m a station Follow tileprocedme described
with a weak signal in "Manual timing preset".
Set another station Start over from step 1
to tile existing
preset munber
To improve tuner reception
When tuner reception is poor, set the CD power
manage function to "(D POWER OFF" The
default setting is "CD POWER ON".
Use buttons on the system for the operation.
1Press CD.
2 Press I/_ to turn off the system.
3Press I/_ while holding II.
"CD POWER OFF" appears in the display.
To set CD power on
Repeat the procedure above and "CD POWER
ON" appears in the display.
Notes
• When "CD POWER OFF" is selected, CD access
time is increased.
• You cannot change the CD power management
setting in the Power Saving Mode (page 29).
To change the AM tuning interval
(except for Middle Eastern
models)
Use buttons on the system for the operation.
The factory settings for AM tuning interval is
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then mrn off the system. While holding down
ENTER, press I/(_) When you change the
interval, all the AM preset stations are erased.
To reset the interval, repeat the same procedure.
Note
You cannot change the AM tuning intmval in the
Power Saving Mode (page 29)
Tips
•The preset stations are retained tbr halfa day even it"
you unplug the powei cmd or if a powei failure
OCClllS.
•If you piess TUNEK,'BAND while the power is off.
the powm turns on automatically and TUNER is
selected as a fimction
• To improve the ieception, adjust the supplied
antennas oi connect all external antenna
• You can also press FLq'4CTION repeatedly on the
1emote to select "TL2qER".
-*t