On operating voltage
Betble opelating tile systenl check that tile operating
voltage of your system is identical with the voltage of
your local power supply
On safety
•Tile system is not disconnected fronl tile AC powe!
source (mains) as long as it is connected to the wall
outlet, even if the system itself has been turned oft'.
• Unplug tbe system from tbe wall outlet (mains) if it
is not to be used for an extended period of time. To
discmmect the power cord (mains lead), pull it out by
the plug. Never pull tbe cord itself
•Should any solid object or liquid fall into the system,
tmplug the system and have it checked by qualified
personnel belore operating it any fi_rther.
• For customers in United States
One blade of the plug is wider than other for tbe
pulpose of safety and will fit to the wall outlet only
one way If you are rulable to inseit the plug fiflly into
the outlet, contact your dealer.
• AC power cord must be changed only at the qualified
seia'ice shop.
On placement
• Do not place tile system in an inclined position
• Do not place the system in locations where it is:
Extlemely hot or cold
Dusty or dilty
Ve!), lmlnid
Subject to vibrations
Subject to direct starlight.
• Use cantion when placing the system or speakers on
surfaces tbat have been specially treated (witb wax,
oil, polish, etc) as staining or discoloration of the
surface may resnlt
On heat build-up
• Although tile systeln beats up during opelation this
is not a malfimction.
• Place tile system in a location with adequate
ventilation to prevent heat bnlld-up in the system.
• If you continuously use this system at a large volmne,
the cabinet tempera0;re of the top, side and bottom
rises considerably To avoid burning youlself, do not
touch the cabinet
• To prevent a malfimction, do not covel the
ventilation hole tbr the cooling fan
On operation
• Iftbe system is blought directly frolll a cold to a
warm location, o! is placed in a very damp room,
moistme may condense on tile lens inside the system.
Shonld this occur, the system will not operate
properly Remove the disc and leave the system
turned on t_r about an hour until the moisture
evaporates.
• When you move the system, take out any disc
If you have any questions or problems concerning your
system, please consult your nearest Soil?, dealer
Notes on discs
• Befole playing clean the disc with a cleaning cloth.
Wipe tile disc from the center out.
• Do not use solvents such as benzene, ttfinne!,
commercially available cleaners or anti-static splay
intended tbr vinyl LPs.
• Do not expose the disc to direct sunlight or heat
sources such as hot air ducts nor leave it in a car
parked in direct starlight.
• Do not use discs encircled with a protection ring.
Tiffs may cause a malfimction to the system
• When using discs that have glue or similar tack?,
substance oil the label side of the disc or that used a
special ink when the label was printed, there is a
chance that the disc or label may become attached to
parts inside this system When this occurs, it may not
be possible to remove the disc, and may also canse
this system to malfmlction. Be sure to check tbat the
label side of tbe disc is not sticky betbre using.
The following b,pes of disc should not be used:
Rental or used discs witb attached seals where the
ghie extends beyond tile seal. Tile perimetel of the
seal oil tile disc is tacky
Discs that have labels printed using a special ink
that feels tacky when touched.
• Discs with non-standard slmpes (e.g., healt, square,
star) cannot be played back on tiffs system.
Attempting to do so may damage the system. Do not
use such discs.