The tape does not record.
•No tape is loaded Load a tape.
•The tab has been removed fwm the tape Cover
the bzoken tab with adhesive tape (page 41)
• The tape has wotmd to the end.
The Deck A does not playback reverse side.
(MHC-GX9000/GN660 only)
•The Deck A only playback flont side of the tape.
This is not a malflmction.
If the system still does not
operate properly after performing
the above measures or other
troubles does not described
above occur, reset the system as
follows:
Use buttons on the system for the operation.
1Unplug the power cord.
2 Plug the power cord back in.
3 Press I/(_ to turn on the system.
4 Press II, ENTER and I/5 at the same time.
The system is reset to the fi_ctory settings. All
the setting are cleared. You should set the
settings you made, such as the preset stations,
clock and timer.
One of the following messages may appear or
flash in the display dnring operation.
CD/MP3
NO STEP
You have clealed all the tracks you programmed
OVER
You have leached the end of the disc while tmmng
and holding _ _ clockwise (or pressing
on the remote) during playback or pause playback.
No Disc
There is no disc in the system.
Push STOP!
You plessed PLAY MODE duling playback.
Step Full!
You tried to program more than 25 steps
Reading
The system is leading intbrmation of the disc. Some
buttons are not available.
Tape
No Tab
You cannot zecord the tape because the tab has been
removed from the tape
No Tape
There is no tape in the tape deck
Timer
OFF TIME NG!
The on time and oft" time of Pla t, Time! o! Time!
Recording is same
SET CLOCK!
You pressed CLOCK/TIMER SELECT before the
clock is set
SET TIMER!
You plessed CLOCK,'TIMER SELECT before Pla t,
Timer or Timer Recording is set.
PUSH SELECT!
You tried to set the clock o! lima during time!
operation
r-
Ut
0
o
5'
I,Q