Grizzly G9983 Beginning Assembly, Handwheel Handle, To install the handwheel handle

Beginning Assembly

Most of your new wide-belt sander has been assembled at the factory, but some setup is required after delivery. We have organized the setup process into steps. Please make sure the sander is placed in its final position in your shop and follow along in the order presented in this section.

Keep loose clothing out of the way of machinery and keep hair pulled back.

Disconnect power to the machine when perform- ing any setup or assem- bly. Failure to do this may result in serious personal injury.

Wear safety glasses dur- ing the entire setup process. Failure to com- ply may result in serious personal injury.

Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.

Handwheel Handle

To install the handwheel handle:

1.Thread the handle into the handwheel as shown in Figure 7.

2.After handle is completely threaded down, tighten the jamnut so the handle will not come loose. Make sure to leave the plastic sleeve loose enough to rotate when you crank the handwheel.

Figure 7. Install handle onto handwheel.

NOTICE

The waxy grease must be completely cleaned from the table column for smooth table height adjustments.

G9983 15" Open-End Wide-Belt Sander -13-