Grizzly G9983 Air Hose, Sanding Belt, To connect the air hose, To install a sanding belt

Air Hose

The air hose connection is located at the regula- tor on the front of the machine.

To connect the air hose:

1.Fit the hose over the regulator nozzle.

2.Secure the hose with a hose clamp as shown in Figure 10 and turn on your air compres- sor.

3.Regulate the air pressure to 75 PSI. This is the normal operating pressure for the Model G9983.

Figure 10. Secure air hose with a hose clamp.

NOTICE

DO NOT exceed 75 lb. of air pressure. Damage to the machine components may result.

NOTICE

The main shut off valve should remain closed until air pressure is needed. This will reduce wear and tear on the air system com- ponents.

Sanding Belt

The Model G9983 is designed for 16" x 48" sand- ing belts.

To install a sanding belt:

1.Open the left-hand side door for access.

2.Make sure the greasy protective coating has been cleaned from the metal belt roller before installing sanding belt.

3.Fit the sanding belt completely over the three sanding rollers as shown in Figure 11. The belt will move counter-clockwise during rota- tion—make sure that the arrows on the inside of the belt point in the direction of rota- tion.

Figure 11. Place belt over the three belt rollers to install. Make sure arrows on inside of belt point in the direction of rotation.

G9983 15" Open-End Wide-Belt Sander -15-