![](/images/new-backgrounds/1283846/28384639x1.webp)
Long term exposure to this machine during operation may cause
hearing loss. Wear approved hearing pro- tection to minimize this risk!
2.Start both the sanding belt and the feed belt, making sure your finger is poised over the STOP button, just in case there is a problem. The
Strange or unnatural noises should be investigat- ed and corrected before operating the machine further. To avoid injury or damage to the machine, DO NOT attempt to make adjustments to the machine without turning it off and unplug- ging it from its power source.
If noises occur that cannot be found by visual inspection, feel free to contact our Service Department for help.
Recommended
Adjustments
Disconnect power to the machine when perform- ing any adjustments. Failure to do this may result in serious person- al injury.
For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.
However, because of the many variables involved with shipping, we recommend that you at least check the following adjustments to ensure the best possible results from your new machine.
All of these adjustments are covered in
Recommended adjustment checklist:
¥Pressure Rollers
¥Oscillation Timing
¥Oscillation Speed
¥Oscillation Return
¥Limit Switch Position
¥Feed Belt Tension
¥Feed Belt Tracking
¥
G9983 15" |