Assembly
To avoid risk of serious injury, DO NOT connect the sander to power until told to do so in the Test Run subsection.
To assemble your combo sander:
1.Using 13mm wrenches, loosen the four motor mount hex bolts (Figure 6) so you can adjust the motor position in the next steps.
Motor Mounting
Hex Bolts (2 of 4)
Figure 6. Motor mounting hex bolts (2 of 4,
viewed from top).
2.With assistance, position the belt housing assembly on the left side of the base, taking care not to pinch the power cords between the assembly and the base.
3.Place the V-belt around both pulleys, and secure the belt housing assembly with the two M10-1.5 x 20 cap screws, lock washers, and flat washers (see Figures 7 & 8)—do not fully tighten the fasteners for now.
Model H8192 1" Belt/8" Disc Combo Sander
Assembly
