Changing the |
| Changing the |
Sanding Belt |
| Sandpaper Disc |
|
|
|
|
|
|
Some sanding belts are designed to sand in only one direction and will have a direction indicated on the back of the belt. The Model H8192 is designed so that the sanding belt travels downward to the sanding table.
To change the sanding belt:
1.DISCONNECT THE SANDER FROM POWER!
2.Unscrew the two knobs from the sanding belt cover and remove the cover from the sander (see Figure 32).
Sanding
Belt
Direction
Figure 32. Sanding belt cover removed.
3.Press down firmly on the tracking adjustment knob to remove the tension from the sanding belt.
4.Roll the old sanding belt off the three pulleys, and roll the new belt back on.
5.Make sure the sanding belt is positioned in the center of all three pulleys.
6.Replace and secure the sanding belt cover.
7.Check and the adjust the sanding belt traction, as instructed on Page 22.
Model H8192 1" Belt/8" Disc Combo Sander
The Model H8192 accepts 8" diameter cloth or paper-backed pressure sensitive adhesive (PSA) sandpaper discs (refer to Accessories on Page 21).
Refer to the Assembly subsection, beginning on Page 13, for detailed instructions for some of the following steps.
To change the sanding disc:
1.DISCONNECT THE SANDER FROM POWER!
2.Remove the sanding disc table, disc dust port, and dust cover.
3.Rotate the disc until you can see the set screw through the access hole (see Figure 33).
4.Using the 2.5mm hex wrench through the access hole in the
Set Screw
Access Hole
