Special
Searching for digital terrestrial TV channels manually
1Open the menu with »MENU«.
2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3Select the line »Source« with »V« or »Λ« and press »OK« to confirm.
Select the option »Air« with »<«, »>«, »V« or »Λ« and press »OK« to confirm.
Caution:
7The antenna power supply (line »Active Antenna Power«) may only be switched on if the antenna is an active indoor antenna with a signal amplifier and it is not already supplied with a voltage via a mains plug (or similar supply). Otherwise you may cause a short circuit and irreparably dam- age your antenna.
4Select the »Active Antenna Power«« with »V« or »Λ«. Switch on the antenna power supply for the antenna with »<« or »>« (»On«).
5Select » Digital Manual Tuning« with »V« or »Λ« and press »OK« to confirm.
– The menu appears.
6Enter the channel number directly with »1 ... 0« and press »OK« to confirm.
found are displayed in the »Results« menu.
7Press »MENU« to finish the setting.
Tuning analogue television channels
This setting is only necessary if you cannot re- ceive any digital channels and you have not car- ried out an analogue search during initial setup. The television channels can be set directly or using the scan.
Switching the television to analogue reception
Note:
7Analogue channels can be selected if the option »Air« or »Cable« has been selected.
1 Open the »Select input source« menu with »
«.
2Depending on the antenna system, select the option »Air« or »Cable« with »V«, »Λ«, »<« or »>« as the input source and press »OK« to confirm.
Note:
7Additional operations are explained in the following sections.
Setting all analogue television channels
Analogue channels are displayed in the channel list after the digital channels.
Note:
7Plug the rooftop antenna cable (for analogue television channels) into the »ANT IN« socket on the television.
1Open the menu with »MENU«.
2Select the line »SOURCE SETUP« with »V« or »Λ« and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3Select the line »Source« with »V« or »Λ« and press »OK« to confirm.
Select the option »Air« or »Cable« with »<«, »>«, »V« or »Λ« and press »OK« to con- firm.
