2
Wireless Exit Sensor
Above is a typical location where installing a conventional
“wired” exit sensor would require cutting and trenching
across more than 50 feet of asphalt driveway.
Gate Opener
Receiver
Driveway
Transmitter
100’ Max
Wireless
RANGE:
12 ft. radius
(max)
SENSOR:
2 feet from
driveway (max)
and 12” deep
Open Gate
Outside
Sensor Range
25 ft. from
gate (min)
Sensor and Module Placement Overview
•DeterminetheoptimumlocationfortheVEHICLESENSORusingtheinformationfoundabovein“Sensorand
 TransmitterPlacementOverview”.Thendigaholeapproximately10-12inchesdeepand24incheslongwithin
 2feetandparalleltotheedgeofthedriveway.Next,digatrenchnomorethan15ftfromthisholetothelocation
 whereyouwillinstallthetransmittermodule.KeeptheVEHICLESENSORandthecableuncoveredatthistime.
IMPORTANT: Clear an area 20 feet in all directions of metal tools, toys and automobiles, to prevent magnetic disturbance
during testing and installation.
Sensor Placement

Determining Sensor Location

For Optimum Performance:

•LocatetheSENSORasfaraspossibleawayfrompowertransformers,powerlines,underground
 gasline,andtelephonelines.
•LocatetheSENSORawayfromgeneralmovingtrafctopreventunwantedactivation.Remember
 thattheSENSORdetectsMAGNETICDISTURBANCEScausedbyavehicle’smassandvelocity.
•Rangedistanceisapproximateandwillvaryduetooutsideinterference,typeofsoil,vehiclemass,
 speed,etc.
•ItisrecommendedthatyouruntheSignalCableinsidePVCconduittopreventaccidentaldamage.
•DonotrunSignalCableinconduitwithotherwiressuchasACpowerorothercontrolwires.
•TheSIGNALCABLECANNOTBESPLICED.Ifyouneedmorewire,contacttheGTOSales 
 Departmentat1-800-543-GATE(4283).
NOTE: Place the transmitter on
the same side of the driveway in
the line of sight of the receiver to
maximize the range.