Haan HD-50 user manual Using Your Duo Steam Sweeper & Floor Sanitizer, Operating Instructions

Using Your Duo™ Steam Sweeper & Floor Sanitizer

i

Be sure to read ALL instructions and warnings

before using your Duo™ Steam Sweeper and Floor Sanitizer.

HELPFUL HAAN® HINT: Never leave the appliance in one spot on any surface for any period of time.

Always place your Duo™ on the Floor Protector/ Resting Mat when stationary and make sure it is turned off when not in use.

Fig 1

Remove film

!Important Warning

Your Steam Sweeper & Floor Sanitizer is designed to clean hard floor surfaces and carpets that will withstand high heat. Do not use on unsealed wood or unglazed ceramic floors. On surfaces that have been treated with wax or on some no-wax floors, the sheen may be removed by the heat and steam action. It is always recommended to test an isolated area of the surface to be cleaned before proceeding. It is also recommended that you check the use and care instructions from the floor manufacturer.

Operating Instructions:

Steam function on hard Floor Surfaces:

Fig 2

	Foot
Small Buttons	Tab

Fig 3

Foot Tab

HELPFUL HAAN® HINT:

When using your Duo™ to clean up wet messes, be sure to wipe the brush bristles with a clean damp rag and allow to dry before using the Duo™ on carpets or rugs.

1)Remove all parts from the packaging.

2)Assemble the unit as described on pgs 6-7.

3)IMPORTANT: Make sure you remove the clear plastic film that is over the Thermal Indicator on the water tank cap. Failure to do this could inhibit the sensor and result in an incorrect reading. DO NOT remove the black sensor (Fig 1).

NOTE: The Pad Tray attachment, which comes attached to the base of the Duo™ in its packaging, must be used in conjunction with the Ultra-Microfiber Pad when using the unit to steam clean hard-surface floors. To use the Duo™ on rugs and carpet, you must remove the tray. The Ultra-Microfiber Pad is not needed when cleaning rugs and carpet, unless you are spot treating (see pgs 13-14 for details).

4)Attach the Pad Tray to the bottom of the Duo™. There are buttons that fit into the bottom of the Duo™ to hold it in place (Fig 2). Place the tray on the floor with the foot tab towards the back of the unit. Be sure the buttons are pointed up and the rough surface that holds the pad is against the floor. Lifting the unit, align the plastic foot tab to the edge of the unit base. Press down and back slightly with the pole, allowing the two small buttons on the Pad Tray to snap into the corresponding holes on the underside of the Duo™ (Fig 3).

pg 8 877 - HAAN DIRECT / 877 - 422 - 6347 www. HAAN USA . com