Fig 18
Fig 19
| | Flax |
| | Wool |
| | Cotton |
| | Silk |
| | Microfiber |
| 5-10x | HAAN Ultra-Microfiber |
| Thinner |
| |
than Microfiber
IMPORTANT
You MUST use the Pad Tray with the Ultra-Microfiber™Pads when using the SV-60 on hard surface floors.
Make sure you always start with completely dry pads. The pad will absorb moisture as it cleans. Once it becomes damp, replace it with a dry pad.
Never leave your Ultra- MicroFiber™ Pad on your SV-60 Steam Vacuum when you have finished using the unit. Once the unit has cooled, remove the pad before storing the SV-60.
Always place your SV-60 on the Resting Mat while it is cooling down to protect your floors.
Operating Instructions: (cont)
Carpet Tray for Higher Pile Carpets:
Because the SV-60 Steam Vacuum does not have the ability to adjust the height of the vacuum base, there is an optional tray designed to accommodate higher pile carpets.
To Attach the High Pile Tray:
1)Turn power OFF.
2)There are 4 raised buttons on the underside of the base of the SV-60 that correspond to indents in the top side of the High Pile Tray. (Fig 18)
3)Set the Pad Tray on the floor with the indents facing up. Align the buttons and press together until you hear the tray snap into place. You are now ready to use the SV-60 on higher pile.
HAAN® Ultra-MicroFiber™Pads:
What is an ultra-microfiber?
An ultra-microfiber is a textile fiber that is thinner than a microfiber. The Ultra-MicroFiber™ by HAAN® Corporation is 5-10 times thinner than common microfiber providing for a significantly higher thread count in the same surface area. The thinner and higher the thread count, the greater the absorption. The HAAN® ultra-microfibers are so thin that more dirt and dust gets trapped between the fibers, making your cleaning easier and less time-consuming. (Fig 19)
The ultra-microfiber pad is made up of multiple layers of super absorbent material. The outer layer is ultra-microfiber on one side and a “hook & loop” system on the other side that attaches easily to the underside of the steam head after the Pad Tray is attached (see directions on pages 10-11). Simply place the pad on the floor with the “hook & loop” side up, and lightly press the SV-60 Steam Vacuum onto it.
As high temperature steam passes through a pad to contact the floor to kill germs, molds and mites. It is natural that the pad gradually absorbs moisture. After a certain length of time, the pad repels water and becomes damp. When the pad becomes saturated, turn the unit OFF and wait until the unit cools down for approximately 5 minutes. Put your foot on a corner of the pad and lift the SV-60 off the pad. Replace with a dry pad, turn the unit back on and continue.
To keep the floor clean and dry, replace the pad when it is dirty and/or saturated.
