Care & Maintenance
HAAN® Helpful Hints:
•The SV-60 may be used to remove fresh stains from carpet. While you normally do not need to use the Pad Tray and Ultra-MicroFiber™ Pad while vacuuming or steaming carpet, you may use both the Pad Tray and Ultra-MicroFiber™ Pad to remove fresh stains from carpet. The pad acts as a “blotter” of sorts, to remove most fresh, wet spills and stains.
First, fill the SV-60 water tank. Snap the tank back into place. Place the Pad Tray and an Ultra-Microfiber™ pad on the bottom of the SV-60 unit. Plug the unit in and press the STEAM button. It takes about 40 seconds for the unit to heat up.
Place the unit over the stain and hold it in place for a few seconds to allow the steam to penetrate the area of the stain.
Push and pull the SV-60 slowly across the area to work the steam into the stain. The pad’s absorbency will work to ‘blot’ the stain from the carpet.
When you have finished using the unit, turn it OFF and place it on the Resting Mat. Allow the unit to cool down for approximately five (5) minutes before removing the Ultra-Microfiber pad from the base.
•You do not have to use a broom and dust pan to clean up loose dirt from your hard surface floors before using the SV-60 Steam Vacuum. The unit acts independently as a vacuum or a steamer or both. For optimal performance, we recommend using the vacuum and steamer functions of the SV-60 simultaneously.
•To ensure the best results when using your SV-60, push the Steam Vacuum forward and backward in slow, even strokes.
w w w. H A A N USA . com | 877 - HAAN DIRECT / 877 - 422 - 6347 | pg 17 |
