Care and Maintenance
Fig 20
Dust
Collection
Bin
Fig 21
indent
indent
Fig 22
Turn levers out to open
Fig 23
Slide up and out
Fig 24
Dust Collection Bin Cleaning and Assembly:
Make sure to use the product with the rectangular filter in place properly, as doing so without it can cause motor damage. Using the
the filter in place could void the warranty.
•Clean out the Dust Collection Bin (Fig 20) when suction becomes weaker than normal and/or the sound of the motor becomes louder than usual.
•After vacuuming with the
to remove the Dust Collection Bin and filter and rinse it thoroughly. (Suction can be weakened when the Dust Collection Bin is full.)
Disassembly Instructions:
1)Grasp the Indent Guides on each side of the Dust Collection Bin and raise the cartridge upward. (Fig 21)
2)After carefully turning the Dust Collection Bin cover over, turn the white levers on each side to point outward.(Fig 22)
3)Grasp the case and detach the clear cover being careful not to spill the dirt inside.
4)Grasp the rectangular filter and remove by sliding upward. (Fig 23)
5)Clean the filter under running water.
7)After cleaning, place the filter in a well- ventilated, shaded area and reassemble when fully dry. (Suction is weakened if reassembled while still wet.)
Assembly Instructions:
(Suction is weakened if the Dust Collection Bin is improperly assembled. Follow the instructions carefully for optimum use)
1)Align the rectangular filter with the guides in the cover and slide in completely.
2)Align the clear cover and press firmly into place. Suction can be weakened if the seal is not tight between the case and the cover.
3)Turn the white levers inward to lock the case and cover. Be sure the levers are completely within the cover in the closed position.
(Fig 24)
4)Firmly press the Dust Collection Bin back into the
pg 14 | 877 - HAAN DIRECT / 877 - 422 - 6347 | www. H A A N USA . com |
