Section 4

4.3 Setting the Time and Date

Note: When setting the time and date, the * key causes the display to back up to the previously flashing character.

Before programming the sampler for the first time, check the real time clock and date settings.

1.Check the real-time clock and date settings by pressing TIME/READ. The display will show the time and date for several seconds:

10:35 AM 24OCT00

2.If the time or date are not correct, press TIME/SET. The time and date will appear on the display, with the hour flashing.

3.Press the appropriate numerical key(s) for the correct hour. When the correct hour flashes on the display, press YES. This will cause the minutes to flash on the display.

4.Using the same procedure, select the correct minutes and press YES. The am/pm indicator will flash.

5.If the desired indicator is flashing on the display, press YES. If the desired indicator is not flashing, press NO. This will cause the other indicator

to flash.

6.Press YES. The month will begin to flash. Select the correct day, month and year using the same procedure as you used to set the time.

7.After the correct year has been entered, the display will read "Synchronize Time-enter at Time". Pressing YES will start the clock. The display will read "Clock is Now Set".

4.4 Bottle Setup Mode

When programming the sampler for the first time, you must first access the bottle setup mode which contains set-up information such as the units for bottle volume (milliliters and gallons) and the bottle volume.

To access the Bottle Setup Mode, the sampler must be in standby state, the program cannot be in progress or "running". The sampler is in standby state when the display indicated any one of the following: "Ready to Start", "Program Complete", or "Program Halted". If the display reads "Program Running", press the CHANGE/HALT key. This will halt the program, thus placing the sensor in the “Program Halted” standby state.

1.With the sampler in standby state, press the * key. The display will read “Enter units for bottle volume, milliliters?”.

2.Press NO to cause other volume units to appear. When the desired units appear on the display, press YES.

3.The display will show "Volume = _ _ _ _ _ mL" (or "Volume = _ _ _ _ _

Gallons"), whichever was chosen in the previous step.

4.Enter the volume for the individual sample bottle by pressing the numerical keys.

5.Press YES to accept the volume.

This completes the bottle setup entries and the sampler is ready to program.

 

Page 23

8544operations.fm

Setting the Time and Date

Page 23
Image 23
Hach 900 manual Section Setting the Time and Date, Bottle Setup Mode, 1035 AM 24OCT00