Section 3

Figure 5 Full Bottle Shut-off

1

2

1.Sample Tubing

2.Full Bottle Shut-off

3.8 Power Connections

Note: Make sure both rubber hold- downs are attached to the clips at each end of the power supply.

The sampler controller operated on 12 V dc which is supplied by an optional ac/dc power converter and/or battery.

The power supply (or battery) is placed in the compartment located directly behind the controller. Pull the rubber hold-downs up and over the clips at each end of the power supply (or battery) to hold it in place.

The short 2-pin cable on the power supply (or battery) connects the controller receptacle labeled 12 V dc.

Batteries available from the manufacturer include a lead-acid gel battery, and nickel-cadmium (Ni-Cad) battery (Cat. No. 1416). The 120 V ac to 12 V dc power converter (Cat. No. 1440) includes a built-in lead-acid battery charger. The Power Converter (Cat. No. 1443) contains a charger for Ni-Cad batteries. 230 V ac and 12 V dc power converters (Cat. No. 1441) are also available but do not come equipped with a built-in battery charger. Stand-alone, wall mount chargers are also available. See APPENDIX for details on batteries and battery charging.

Important: Whenever electricity is present, there is a possibility of electrical shock. Before connecting the sampler to an ac power source, the following safety precautions should be taken:

Check the power source to make sure that it satisfies the ac power requirements of the sampler.

Make sure that all electrical installations and connections are in accordance with national and local electrical codes.

Page 16

 

Power Connections

8544install.fm

Page 16
Image 16
Hach 900 manual Power Connections