Haier 309292L important safety instructions HC Conversion Kit

244919 HC Conversion Kit

Part No. 244919 Conversion Kit converts PRO Xs3 standard coating guns (Part Nos. 244400 and 244579) to high conductivity guns (244575 and 244576). For fur- ther instruction and parts, see manual 309453.

The kit is for use with fluids with low resistivity values.

WARNING

Pressurized Equipment Hazard

To reduce the risk of an injury, follow the Pressure Relief Procedure in your gun manual before installing this kit.

1.	Turn the ES ON/OFF valve OFF.
2.	Flush and relieve the pressure.
3.	Disconnect the fluid and air lines to the gun.

Installation

9.Slide the tube case (1e) onto the barrel inlet, over the o-ring (2b). The coiled tube (1a) will compress slightly.

10.Insert the end of the coiled tube (1a) into the bracket

(3). Make sure the ferrules (1c, 1b) seat on the bracket.

11.Secure the bracket by tightening the swivel (A). Tighten the nut (1d). Reinstall the exhaust tube (B) and clamp (C).

12.Reconnect the fluid and air lines to the gun.

5	2
	1b
2a
	1c
2b	1d

4.	Remove the fluid tube and fittings.
5.	Remove the fluid inlet bracket.
6.	Install the new bracket (3) from the kit loosely. See
	FIG. 3.
7.	Place the spacer (5) in the barrel inlet. Apply Graco
	dielectric grease (4) to the o-rings (2a, 2b) and to
	both threads of the fluid fitting (2). Thread the fitting
	into the barrel inlet.
8.	Thread the nut (1d) onto the fitting (2). Make sure
	the ferrules (1c and 1b) are on the tube (1a) and are
	seated on the fitting (2) before tightening the nut
	(1d).

1e

1a

1e

1e 1e

FIG. 3: 244919 Conversion Kit

3

A

B

C

1e

ti10674a

309292L 11