Installation procedure
Install indoor unit
5.Drain hose
(a)The drain hose should always have a slant degree (1/50~1/100) to avoid the protruding part or causing water flow bend.*
Good pipe system | Improper pipe system |
Suspending screw bolt | 1.5m*2m |
| Air outlet |
Insulation |
|
| 1/100 or more slant degree |
Avoid protruding part
Do not have bend |
Do not put pipe under water |
(b)When connecting the drain hose with equipment, be sure not to use too much force to the pipe on one side of the equipment.At the same time, the fixation of pipe should be close to equipment as possible as it can.
(c)For the drain hose, it can be the local bought stiff PVC pipe for normal purpose. When connecting, insert the end of PVC pipe into the drain hole, then use drain hose and wire fastener to fix them tight. The bond can not be used to connect drain hole and drain hose.
Drain hole | Drain hose | ||||
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Drain hole Seal cushion (used for partition) (accessory)
Main unit
Drain hose
Connector (local bought)
**PVC*******
Bonded Seal cushion (used for partition) (accessory) Wire fastener (accessory)
Seal cushion (used for partition) (accessory)
22