Haier DD400RS manual Installation

English

Installation

1.Take off hinge cover(Part #1, page 3) with upwards motion. Refer to illustration below:

2.Take the anti-tip bracket and screws from the accessory bag. Tighten the anti-tip bracket on the top of the product with screws as follows in the illustration. Note: Follow instructions properly or you may do damage to product.

SCREW

ANTI-TIP BRACKET

SCREW

ANTI-TIP BRACKET

SCREW

ANTI-TIP BRACKET

3.Pull upper drawer open and attach the anti-tip bracket to counter by screw as seen below. Adjustment of the leveling legs under the unit may be necessary for a proper fit in the cabinet opening. Start with the rear legs(if necessary) before you slide the unit fully into the opening-rise or lower the rear legs to make the unit fit properly. Then carefully slide the unit into opening as not to damage accidently cabinetry or the floor. Then perform the same adjustments to the front leveling legs to bring the front of unit to the proper level to install the anti-tip bracket and fit evenly under the counter.

Kitchen

Cabinet

Screwdriver

Kitchen Cabinet

30~50

Screwdriver

4.Another set of anti-tip brackets for side installation is provided as option when the counter top is granite and hard to fix by screws. This set of brackets include two anti-tip brackets and eight screws for installation on left side and right side of the cabinet. Below illustration shows this, the drawer needs to be open to perform this procedure.

Right side Left side

5