Haier DW-7777-01 manual Helpful Tip, Direct wire method, 3a. Power supply cord method

English

HELPFUL TIP:

Wiring the dishwasher will be easier if you route wire

into the cabinet opening from the left side.

3. Direct wire method:

Cut a 3/4” (1.9cm) hole ”C” in right hand cabinet side, rear or floor. Optional locations are shown. Wood Cabinet: Sand hole until smooth.

3a. Power supply cord method:

Cut a 11/2”(3.8cm) hole “D”in right-hand cabinet rear

or side. Optional locations are shown. Wood cabinet:Sand hole until smooth.

4.Run wire into house wiring junction box. Use strain relief method provided with junction box. If no strain relief is provided, install

a UL-listed/CSA-certified clamp connector for flexible-

type wire. If installing conduit, attach a UL-listed/CSA- certified conduit connector to junction box.

4a. Install a mating, three-prong, grounding- type wall receptable “E”in the cabinet next to the dishwasher opening. Go to step 6.

5. Run other end of wire through cabinet hole. Cable must extend to the left front of cabinet opening. Go to step 6.

Install a mating, three-prong, grounding-type wall

receptacle “E”in the cabinet next to the dishwasherE opening. Go to step 6.

Water line

HELPFUL TIP:

Routing the water line through the left side of

cabinet opening will make water connection easier.

6.Cut a 1/2”(1.3 cm) minimum hole “F” in left-hand

cabinet side,rear or floor. Optional locations are shown. (The hole “F” is about 1-3/5” higher than hole “C” or hole “D”)

7.Measure total length of copper tubing “G” required.

Attach copper tubing to water line with manual shut- off valve. Carefully feed copper tubing through hole in cabinet (copper tubing will bend and kink easily) until it is far enough into the cabinet opening to connect it to dishwasher inlet on the front left of dishwasher.

12