1. Carefully remove the clear plastic film from the control panel.
2. Press POWER once to turn on the air conditioner.
NOTE: When the air conditioner is first plugged in, the LED display will show “88” for 3 seconds.
After the air conditioner is turned on for the first time, the display will show the
temperature 72˚ F and the fan is automatically set to Low speed and the Mode indicator
will show ENERGY SAVE.
NOTE: To switch the temperature display between Fahrenheit (F) and Celsius(C), the air
conditioner must be plugged in, and turned on. The change cannot be done using the
remote control.
• ESA415M, ESA418M: To switch between °F and °C,press UP and DOWN buttons simultaneously
and hold for 3 seconds.
• ESA424K: To switch between °F and °C, press POWER button and hold for 5 seconds.
3. Select Mode. Refer to “Mode.”
4. Select Speed. Refer to “Speed.”
5. Set Timer. Refer to “Temp/Time”
6. Reset the filter. Refer to “Filter Reset”
MODE
1. Press mode until you see the indicator light come on next to the desired setting.
2. Choose Fan, Cool, Energy Save, or Dehum.
FAN— Only the fan runs. Press SPEED to select High, Med or Low fan speed. The display shows
the current room temperature.
COOL— Cools the room. Press SPEED to select High,Med , Low or Auto Cool fan speed. Press the
TEMP/TIME up or down arrow button to adjust the temperature.
ENERGY SAVE— In this mode the fan runs only when cooling is needed. The fan will run for
3 minute after the compressor shuts off. The fan then cycles on for 1 or 2
minutes at 10 minute intervals until the temperature in the room is above the
set temperature. The compressor then turns back on.
DEHUM— Aids in removing humidity from the room. This setting will NOT cool the room.
STARTING THE AIR CONDITIONER cont.
ENGLISH

PAGE 22 USING YOUR AIR CONDITIONER