Hand Held Products 4200 quick start Inspecting Cords and Connectors, Replacing the Interface Cable

The imager’s housing may also be cleaned the same way.

!Caution:

Do not submerge the imager in water. Do not use abrasive wipes or tissues on the imager’s window – abrasive wipes may scratch the window.

Never use solvents (e.g., acetone, benzene, ether, or phenol-based agents) on the housing or window – solvents may damage the finish or the window.

Inspecting Cords and Connectors

Inspect the imager’s interface cable and connector for wear or other signs of damage. A badly worn cable or damaged connector may interfere with imager operation. Contact your Hand Held Products distributor for information about cable replacement.

Replacing the Interface Cable

The standard interface cable is attached to the imager with an 10-pin modular connector. When properly seated, the connector is held in the IT4200 imager’s handle by a flexible retention tab. The interface cable is designed to be field replaceable.

•Order replacement cables for the IT4200 from an authorized distributor.

•When ordering a replacement cable, specify the cable part number of the original interface cable.

8 IMAGETEAM™ 4200 Quick Start Guide