Harbor Freight Tools 38123 instruction

COMBINATION 4 X 6 INCH

BELT SANDER

38123

ASSEMBLY AND OPERATING INSTRUCTIONS

®

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our Web site at: http://www.harborfreight.com

TO PREVENT SERIOUS INJURY,

READ AND UNDERSTAND ALL WARNINGS

AND INSTRUCTIONS BEFORE USE.

Copyright© 2005 by Harbor Freight Tools® . All rights reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.

For technical questions and replacement parts, please call 1-800-444-3353

MANUAL REV 05/05

Image 1

Harbor Freight Tools 38123 operating instructions For technical questions and replacement parts, please call

Contents

38123 For technical questions and replacement parts, please call General Safety Rules SpecificationsSave this Manual Work Area Personal Safety Electrical Safety Specific Safety Rules ServiceTool USE and Care Industrial applications must follow Osha requirements Grounded Tools Tools with Three Prong Plugs Grounding Extension Cords Double Insulated Tools Tools with TWO Prong Plugs See Figure C Symbology To Secure The Sander Base Assembly To a Workbench Assembly InstructionsTo Mount The Table Assembly Unpacking Figure F To Adjust The Worktable For Vertical Sanding To Install The BackstopOperating Instructions See Figure G SKU For technical questions, please call See Figure To Level The Worktable AssemblySee Figure J See Figure K To Install And Adjust The Sanding Belt Sanding Methods Surface Sanding On The Sanding Belt ON/OFF Locking Switch Sanding Methods Sanding Curved Edges Sanding Methods End Sanding On The Sanding Belt Symptom Probable Cause Remedy Troubleshooting Do not use damaged equipment INSPECTION, MAINTENANCE, and CleaningTo replace the timing Drive Belt See Figure Q, next See Figure Q Please Read the Following Carefully Parts List Assembly Drawing