2.Set the Worktable (35) on its side, and align its mounting holes with the mounting holes in the Table Support (36). (See Figure F.)
3.Attach the Table Support (36) to the Worktable (35) using the Hex Screws (6), Lock Washers (7), and Flat Washers (8). (See Figure F.)
TABLE SUPPORT (36)
WORKTABLE (35)
FLAT WASHER (8)
LOCK WASHER (7)
HEX SCREW (6)
FIGURE F
4.Position the Table Support (36) in the corresponding mounting holes located on the side of the Base (42). (See Figure G, next page.)
5.Place a Flat Washer (8) on the shaft of the Knob (1). Then, screw the Knob into the threaded hole in the Base (42). (See Figure G.)
6.Loosen the three Hex Screws (6), and adjust the Worktable (35) so there is a maximum of 1/16” space between the Sandpaper Pad (27) and the Worktable. Then, retighten the Hex Screws. (See Figures F and G.)
SKU 38123 | For technical questions, please call | Page 10 |
